Author Topic: Auto-reconnect on Bridge-it new firmware  (Read 2763 times)


  • Default Avatar
  • Posts: 2
  • Reply #0
    July 09, 2015, 07:26:00 pm

Hi !

Since the last update I cannot find the auto reconnect function.
Usually that was the first setting in settings/system, but I can't find it...

Help \o/


  • Administrator
  • Posts: 50
  • Reply #1
    July 10, 2015, 09:17:06 am

Auto Reconnect is disabled by default. When enabled the dialing codec attempts to reconnect if data is temporarily lost over an IP connection. To adjust the setting:
1.   Press the HOME home button button to return to the Home screen, select Connect, then select IP and press the Ok button button.
2.   Select the IP Session mode you are using to connect.
3.   Select Setup and press Ok button.
4.   Navigate to A/Recon and press Ok button to toggle between Enabled and Disabled.


  • Default Avatar
  • Posts: 2
  • Reply #2
    July 11, 2015, 12:02:04 am

Ok thanks !   ;)


Join Forum - It's Free

Become a member of the Tieline forum today!

Member Login

Email AddressPassword
Forgot your password?